# # /etc/rc.conf - Main Configuration for Arch Linux # # ----------------------------------------------------------------------- # LOCALIZATION # ----------------------------------------------------------------------- # # LOCALE: available languages can be listed with the 'locale -a' command # DAEMON_LOCALE: If set to 'yes', use $LOCALE as the locale during daemon # startup and during the boot process. If set to 'no', the C locale is used. # HARDWARECLOCK: set to "UTC" or "localtime", any other value will result # in the hardware clock being left untouched (useful for virtualization) # Note: Using "localtime" is discouraged. # TIMEZONE: timezones are found in /usr/share/zoneinfo # KEYMAP: keymaps are found in /usr/share/kbd/keymaps # CONSOLEFONT: found in /usr/share/kbd/consolefonts (only needed for non-US) # CONSOLEMAP: found in /usr/share/kbd/consoletrans # USECOLOR: use ANSI color sequences in startup messages # LOCALE="en_US.UTF-8" DAEMON_LOCALE="no" HARDWARECLOCK="UTC" TIMEZONE="Canada/Pacific" KEYMAP="us" CONSOLEFONT= CONSOLEMAP= USECOLOR="yes" # ----------------------------------------------------------------------- # HARDWARE # ----------------------------------------------------------------------- # # MODULES: Modules to load at boot-up. Blacklisting is no longer supported. # Replace every !module by an entry as on the following line in a file in # /etc/modprobe.d: # blacklist module # See "man modprobe.conf" for details. # MODULES=() # Udev settle timeout (default to 30) UDEV_TIMEOUT=30 # Scan for FakeRAID (dmraid) Volumes at startup USEDMRAID="no" # Scan for BTRFS volumes at startup USEBTRFS="no" # Scan for LVM volume groups at startup, required if you use LVM USELVM="no" # ----------------------------------------------------------------------- # NETWORKING # ----------------------------------------------------------------------- # # HOSTNAME: Hostname of machine. Should also be put in /etc/hosts # HOSTNAME="myhost" # Use 'ip addr' or 'ls /sys/class/net/' to see all available interfaces. # # Wired network setup # - interface: name of device (required) # - address: IP address (leave blank for DHCP) # - netmask: subnet mask (ignored for DHCP) # - broadcast: broadcast address (ignored for DHCP) (optional) # - gateway: default route (ignored for DHCP) # # Static IP example # interface=eth0 # address=192.168.0.2 # netmask=255.255.255.0 # broadcast=192.168.0.255 # gateway=192.168.0.1 # # DHCP example # interface=eth0 # address= # netmask= # gateway= interface= address= netmask= broadcast= gateway= # Setting this to "yes" will skip network shutdown. # This is required if your root device is on NFS. NETWORK_PERSIST="no" # Enable these netcfg profiles at boot-up. These are useful if you happen to # need more advanced network features than the simple network service # supports, such as multiple network configurations (ie, laptop users) # - set to 'menu' to present a menu during boot-up (dialog package required) # - prefix an entry with a ! to disable it # # Network profiles are found in /etc/network.d # # This requires the netcfg package # #NETWORKS=(main) # ----------------------------------------------------------------------- # DAEMONS # ----------------------------------------------------------------------- # # Daemons to start at boot-up (in this order) # - prefix a daemon with a ! to disable it # - prefix a daemon with a @ to start it up in the background # # If something other takes care of your hardware clock (ntpd, dual-boot...) # you should disable 'hwclock' here. # DAEMONS=(hwclock syslog-ng network netfs crond)